Scyld, RMI, and ProActive

[Simon Frost]

Dear Beowulf list,

I'm sure that this is a dumb question, but I am a relative newbie...

I'm trying to get RMI working on my Scyld system.  I'm using the ProActive 
libraries (http://www-sop.inria.fr/sloop/javall/), which make the whole RMI 
thing much easier.  The problem is, when I try to create an RMI node on a 
slave in the RMI registry, it only puts a node on the master, not on the 
slave i.e.

./startNode.sh rmi://.1/1

puts a JVM on the master node (-1), rather than on node 1.

Alternatively, I can bpsh to the node in question:

bpsh .1 (fullpath)/startNode.sh rmi://.1/1

This initially mounts a node, but then I get an ArrayIndexOutOfBounds 
exception.

Any ideas?
Thanks!
Simon

Simon D.W. Frost, M.A., D.Phil.
Department of Pathology
University of California, San Diego
Antiviral Research Center
(Formerly: UCSD Treatment Center)
150 W. Washington St., Suite 100
San Diego, CA 92103
USA

Tel: +1 619 543 8080 x275
Fax: +1 619 298 0177
Email: sdfrost at ucsd.edu
Work W3: http://www.avrctrials.org
Personal W3: http://www.simonfrost.com