Invalid EEPROM checksum on 1.09j-t
Jason Goldschmidt
jgoldsch@bucknell.edu
Sat May 6 01:54:53 2000
Hi.
I am using the eepro100 driver that comes w/ 2.2.15 (1.09j-t). At boot up
I get this message when the module loads:
May 6 00:49:45 dieselmeat kernel: eth0: Invalid EEPROM checksum 0x79f5,
check settings before activating this device!
May 6 00:49:45 dieselmeat kernel: eth0: Intel PCI EtherExpress Pro100 at
0xc6849000, 00:E0:ED:3D:F3:E1, IRQ 9.
May 6 00:49:45 dieselmeat kernel: Board assembly 771d6d-134, Physical
connectors present: RJ45
May 6 00:49:45 dieselmeat kernel: Primary interface chip unknown-15 PHY
#1.
May 6 00:49:45 dieselmeat kernel: General self-test: passed.
May 6 00:49:45 dieselmeat kernel: Serial sub-system self-test: passed.
May 6 00:49:45 dieselmeat kernel: Internal registers self-test: passed.
May 6 00:49:45 dieselmeat kernel: ROM checksum self-test: passed
(0x49caa8d6).
May 6 00:49:45 dieselmeat kernel: Receiver lock-up workaround
activated.
The interface is up, everything seems normal, but I can't get a route out
the interface.
The card works fine w/ 2.2.14 which used 1.06 (I believe) and gives me
this message:
May 6 01:40:25 dieselmeat kernel: eth0: Intel EtherExpress Pro 10/100 at
0xf4e0, 00:A0:C9:39:E2:C1, IRQ 9.
May 6 01:40:25 dieselmeat kernel: Board assembly 661949-004, Physical
connectors present: RJ45
May 6 01:40:25 dieselmeat kernel: Primary interface chip DP83840A PHY
#1.
May 6 01:40:25 dieselmeat kernel: DP83840 specific setup, setting
register 23 to 8462.
May 6 01:40:25 dieselmeat kernel: General self-test: passed.
May 6 01:40:25 dieselmeat kernel: Serial sub-system self-test: passed.
May 6 01:40:25 dieselmeat kernel: Internal registers self-test: passed.
May 6 01:40:25 dieselmeat kernel: ROM checksum self-test: passed
(0x49caa8d6).
May 6 01:40:25 dieselmeat kernel: Receiver lock-up workaround
activated.
Thanks in advance
-Jason
*************************************)
Jason Goldschmidt jgoldsch@acm.org *)
http://coral.bucknell.edu/~jgoldsch *)
"My Reality Check Bounced" *)
-Scott Adams *)
*************************************)
-------------------------------------------------------------------
To unsubscribe send a message body containing "unsubscribe"
to linux-eepro100-request@beowulf.org