[eepro100] Intel Ethernet problem on Redhat 7.0

[Alvin Oga]

hi ya gary

rh-7.0 uses the 2.2.16-22 kernel

generic 2.2.16/drivers/net/eepro100.c is v1.07j-t  ( about 50-50
lines down 

rh modifies their eeproo100.c

i too use a modified eepro100.c 

to check if the eepro drive is a module or kernel
a.   lsmod  -- > see if its listed

b.   grep EEPRO 2.2.16/.config
	change it to modules
	and recompile and install modules too
or
c.  use linux-2.4.0 kernel ... works ok...out of the box...

have fun
alvin

configure /etc/sysconfig/network-scripts
	ifcfg-eth0 and ifcfg-eth1   for the two NICs


On Wed, 10 Jan 2001, Gary Carr wrote:

> I am running a Tyon Tiger 200 S2505 motherboard which has 2 on board Intel
> 82559 100MB chips. I am getting a random error in my log files that
> read: eth0: card reports no resources. I found the information about a
> custom driver to fix this however I am not sure how I can find out which
> version of which driver I am running now.
> 
> Can someone tell me how to determine which driver I am running as well as
> the driver version and if it is loaded as a module or compiled into the
> kernel? Also, is it possible to configure seperate ip gateways from seperate
> net blocks for each ethernet card?
> 
> 
> Thanks in advance,
> 
> 
> Gary
> 
> 
> 
> _______________________________________________
> eepro100 mailing list
> eepro100@scyld.com
> http://www.scyld.com/mailman/listinfo/eepro100
>