[eepro100] Multiple eepro100 cards: specific order

[Adrian Yee]

Michael,

You can try adding:
append="pci=reverse"
to your lilo.conf (that's if you use lilo).  I'm not 100% sure if it'll
work, but I use it so it makes the kernel scan my pci bus in reverse to
make my Promise controller hda/b/c/d instead of the onboard controller.
Of course this won't work too well if you have lots of nics and want to
remap them in funky orders :)

Adrian

On Thu, 14 Jun 2001, Michael McConnell wrote:

> Hi there folks
>
> Is there any mechanism to request that eepro100 cards are brought up in a
> specific order?
>
> The setup here has an onboard eepro100 on the motherboard, and a second
> eepro100 card plugged in.  What we are trying to do is get the onboard one
> as eth0 and the card as eth1.
>
> Is this possible?
>
> -- Michael "Soruk" McConnell
> .signature: File not found or assimilated into the Borg Collective.
>
>
> _______________________________________________
> eepro100 mailing list
> eepro100@scyld.com
> http://www.scyld.com/mailman/listinfo/eepro100
>