[eepro100] MAC address incorrect

[Crisp, Will]

Turns out I didn't have the right driver, I think I downloaded one of the
alternative versions listed on the eepro100 support page...when I tried
again with the version written by Mr. Becker it worked perfectly.  Thanks!  

-Will

Updated driver messages:

eepro100.c:v1.13 1/9/2001 Donald Becker <becker@scyld.com>
  http://www.scyld.com/network/eepro100.html
eth0: OEM i82557/i82558 10/100 Ethernet at 0xc8827000, 00:90:27:C5:F0:31,
IRQ 11.
  Receiver lock-up bug exists -- enabling work-around.
  Board assembly 734938-001, Physical connectors present: RJ45
  Primary interface chip i82555 PHY #1.
  General self-test: passed.
  Serial sub-system self-test: passed.
  Internal registers self-test: passed.
  ROM checksum self-test: passed (0x04f4518b).
 

-----Original Message-----
From: Donald Becker
To: Crisp, Will
Cc: 'eepro100@scyld.com'
Sent: 3/24/01 2:59 AM
Subject: Re: [eepro100] MAC address incorrect

On Fri, 23 Mar 2001, Crisp, Will wrote:

> 	It appears my Ethernet card's address is being incorrectly
> determined when the driver for my card loads.  I have run the
diagnostics on
> the card and it determines the address is:

What driver version are you using?
Perhaps it's an older driver version that doesn't understand the current
large EEPROMs.

> eth0: Invalid EEPROM checksum 0x60fe, check settings before activating
this
> device!
> eth0: Intel EtherExpress Pro 10/100 at 0x1000, 00:A4:00:80:D2:9C, IRQ
11.
>   Receiver lock-up bug exists -- enabling work-around.
>   Board assembly 800080-000, Physical connectors present:
>   Primary interface chip None PHY #0.

Yup, this won't work.



Donald Becker				becker@scyld.com
Scyld Computing Corporation		http://www.scyld.com
410 Severn Ave. Suite 210		Second Generation Beowulf
Clusters
Annapolis MD 21403			410-990-9993