[realtek] Problem with Accton EN1207D-TX

[Ville Herva]

I'm unable to get the rtl8129.o working for an EN1207D-TX (the one HP
ships with their Kayak PC workstations):

lspci -vv:

01:0b.0 Ethernet controller: Accton Technology Corporation: Unknown device
1210
(rev 10)
        Subsystem: Hewlett-Packard Company: Unknown device 9206
        Control: I/O+ Mem+ BusMaster- SpecCycle- MemWINV- VGASnoop-
ParErr- Stepping- SERR+ FastB2B-
        Status: Cap+ 66Mhz- UDF- FastB2B+ ParErr- DEVSEL=medium >TAbort-
<TAbort- <MAbort- >SERR- <PERR+
        Interrupt: pin A routed to IRQ 9
        Region 0: I/O ports at a800
        Region 1: Memory at fc7efc00 (32-bit, non-prefetchable)
        Expansion ROM at fc7c0000 [disabled]
        Capabilities: [50] Power Management version 2
                Flags: PMEClk- DSI- D1+ D2+ AuxCurrent=375mA
PME(D0-,D1+,D2+,D3hot+,D3cold+)
                Status: D0 PME-Enable+ DSel=0 DScale=0 PME-


When I try to insmod:
root@terminator:/root/becker>insmod rtl8139.o
rtl8139.o: init_module: Device or resource busy
Hint: insmod errors can be caused by incorrect module parameters,
including invalid IO or IRQ parameters


This is with 2.2.19pre2 and the newest rtl8129.c from skyld.com.

It also happens with 2.4.0 and its default rtl8129.c.

I disabled PnP OS from bios. 

Of course the card works in NT (albeit its driver is buggy). Lists the
following information: IRQ 9, IO range A800-A8FF. (The same as lspci.)

What should I do? From the archive, I see that people have had success
with cards that appear as "Accton Technology Corporation: Unknown device
1211" in lspci. Is this 1210 thing supported?

(I'd appreciate CC'ing me since I'm not subscribed, but I will read the
archive.)

 
-- v --

v@iki.fi