[realtek] rtl8029 vs full-duplex

[thomas . kral]

Hello there,

Sorry for NOT posting this elsewhere, I have not found any 8029 related 
lists.

How can I set rtl8029 to a full-duplex? I run ne2k-pci.o driver it works 
just about fine. I put the following into /etc/modules.conf in a good 
faith I may get on full-duplex. I have got three PCI slots.

alias eth0 ne2k-pci
options eth0 full_duplex=1,1,1

./lsmod says..
Module                  Size  Used by
ne2k-pci                4224   1  (autoclean)
8390                    5924   0  (autoclean) [ne2k-pci]
af_packet               6136   0  (autoclean)
unix                   11336  39  (autoclean)

./ne2k-pci-diag -fa says..
ne2k-pci-diag.c:v2.01 1/8/2001 Donald Becker (becker@scyld.com)
 http://www.scyld.com/diag/index.html
Index #1: Found a Realtek 8029 adapter at 0xec00.
Initial window 3, registers values by window:
  Window 0: 22 04 70 6f 03 00 00 00 42 6f 50 43 21 00 00 00.
  Window 1: 62 00 00 b4 a2 8c 26 70 00 00 00 80 00 00 00 00.
  Window 2: a2 00 80 ff 40 ff ff ff ff ff ff ff cc e0 c9 bf.
  Window 3: e2 30 ff 00 ff 00 30 ff ff ff ff ff ff ff 29 80.
 RTL8029 transceiver: 10baseT/coax (autoselected on 10baseT link beat) 
half duplex.
  0K boot ROM.

 No interrupt sources are pending (00).
Parsing the EEPROM of a RTL8029:
 Station Address 00:00:B4:A2:8C:26 (used as the ethernet address).
 Configuration is 30 00:
   0K boot ROM, half duplex
   Transceiver: 10baseT/coax (autoselected on 10baseT link beat).
 PCI Vendor ID 0xa5a5  Device ID 0xa5a5
  Subsystem ID: vendor 0xa5a5 device 0xa5a5

./mii-diag says..
Using the default interface 'eth0'.
SIOCGMIIPHY on eth0 failed: Operation not supported


Thanks so much.
Thomas