Problems with DS21143 (II)

[Martin Josko]

Hello again,

here are the error messages with the latest tulip driver

dmesg:
tulip.c:v0.90k 2/1/99 becker@cesdis.gsfc.nasa.gov
eth0: Digital DS21143 Tulip rev 33 at 0xd800, 00 00 d1 1b fd 41, IRQ 9.
eth0:  EEPROM default media type Autosense.
eth0:  Index #0 - Media MII (#11) described by a 21142 MII PHY (3)
block.
eth0:  Index #1 - Media 10base2 (#1) described by a 21142 Serial PHY (2)
block.
eth0: ***WARNING***: No MII transceiver found!
eth0: MII transceiver 0 status ffff.
  PCI latency timer (CFLT) is unreasonably low at 0.  Setting to 64
clocks.    



tulip-diag.c:v1.07 2/10/99 Donald Becker (becker@cesdis.gsfc.nasa.gov)
Index #1: Found a Digital DS21143 Tulip adapter at 0xd800.
 Port selection is 100mbps-SYM/PCS 100baseTx scrambler, half-duplex.
 Transmit started, Receive started, half-duplex.
  The Rx process state is 'Waiting for packets'.
  The Tx process state is 'Idle'.
  The transmit threshold is 128.
EEPROM transceiver/media description for the Digital DS21143 Tulip chip.

Leaf node at offset 40, default media type 0800 (Autosense).
 2 transceiver description blocks:
  Media MII, block type 3.
   MII interface PHY 0 (media type 11).
   21143 MII initialization sequence is 2 words: 0821 0000.
   21143 MII reset sequence is 3 words: 0821 0001 0000.
   Media capabilities are 7800, advertising 01e1.
   MII interrupt on GPIO pin -1.
 ***WARNING***: No MII transceivers found!      

thanks for your help in advance 

regards

Martin
--
Martin Josko, Institut fuer Informatik der LMU    Tel.: +49/89/2178-2243
LFE Programmier- und Modellierungssprachen        FAX : +49/89/2178-2211
mailto:Martin.Josko@informatik.uni-muenchen.de          Oettingenstr. 67
http://www.informatik.uni-muenchen.de/~Martin.Josko     D-80538 Muenchen