Problems with DS21143
Martin Josko
Martin.Josko@informatik.uni-muenchen.de
Wed Feb 17 09:54:57 1999
Donald Becker wrote:
>
> On Tue, 16 Feb 1999, Martin Josko wrote:
>
> > Subject: Problems with DS21143
> ...
> > tulip.c:v0.90 10/20/98 becker@cesdis.gsfc.nasa.gov
> > eth0: Digital DS21143 Tulip at 0xd800, 00 00 d1 1b fd 41, IRQ 9.
> > eth0: EEPROM default media type Autosense.
> > eth0: Index #0 - Media MII (#11) described by a 21142 MII PHY (3)
> > block.
> > eth0: Index #1 - Media 10base2 (#1) described by a 21142 Serial PHY (2)
> > block.
>
> Are you using the 10base2 interface?
> 10base2 doesn't have a link beat, so you must specify that when you load the
> module (or use a newer 'ifconfig' program).
>
> > eth0: MII transceiver #1 config 3100 status 7849 advertising 0101.
> > eth0: Advertising 01e1 on PHY 1, previously advertising 0101.
>
> You don't have link beat on the MII transceiver.
> And that's a *very* curious initial advertising setting!
>
> > Here some outputs from tulip-diag:
> >
> > tulip-diag.c:v1.07 2/10/99 Donald Becker (becker@cesdis.gsfc.nasa.gov)
> > Index #1: Found a Digital DS21143 Tulip adapter at 0xd800.
> > Port selection is MII, half-duplex.
> > Transmit started, Receive started, half-duplex.
> > The Rx process state is 'Waiting for packets'.
> > The Tx process state is 'Idle'.
> > The transmit threshold is 128.
>
> Looks good.
>
> Donald Becker becker@cesdis.gsfc.nasa.gov
> USRA-CESDIS, Center of Excellence in Space Data and Information Sciences.
> Code 930.5, Goddard Space Flight Center, Greenbelt, MD. 20771
> 301-286-0882 http://cesdis.gsfc.nasa.gov/people/becker/whoiam.html
Sorry, I think it was my failure. Now it works
with the following entry in /etc/conf.modules:
options tulip options=11
--
Martin Josko, Institut fuer Informatik der LMU Tel.: +49/89/2178-2243
LFE Programmier- und Modellierungssprachen FAX : +49/89/2178-2211
mailto:Martin.Josko@informatik.uni-muenchen.de Oettingenstr. 67
http://www.informatik.uni-muenchen.de/~Martin.Josko D-80538 Muenchen