[tulip-bug] LNE100Tx problem not on SMP

[Benjamin Hille]

To confirm the problem stated by Mark Staggs.
I have a single AMD Duron system with RH 7
I have try both normal and test driver and they both have the same
behaviour. Activity on the link but no packet going through.

tulip-diag.c:v2.04 9/26/2000 Donald Becker (becker@scyld.com)
 http://www.scyld.com/diag/index.html
Index #1: Found a ADMtek AL985 Centaur-P adapter at 0xe400.
 Port selection is 100mbps-SYM/PCS 100baseTx scrambler, half-duplex.
 Transmit stopped, Receive stopped, half-duplex.
  The Rx process state is 'Waiting for packets'.
  The Tx process state is 'Stopped'.
  The transmit threshold is 128.
 Interrupt sources are pending!  CSR5 is fc06c012.
   Tx complete indication.
   Link passed indication.
   Early Rx indication.
 The Comet MAC registers are 124c124c ffff124c filter 8000000000000000.
WARNING: The EEPROM is missing or erased!
 Use '-a' or '-aa' to show device registers,
     '-e' to show EEPROM contents, -ee for parsed contents,
  or '-m' or '-mm' to show MII management registers.

The IRQ used by the card is 11.
lspci -v
00:0d.0 Ethernet controller: Bridgecom, Inc: Unknown device 0985 (rev
11)
 Subsystem: Bridgecom, Inc: Unknown device 0574
 Flags: bus master, medium devsel, latency 32, IRQ 11
 I/O ports at e400
 Memory at d8008000 (32-bit, non-prefetchable)
 Capabilities: [c0] Power Management version 2

By the way is anything wrong with my EEPROM ?