Raw ethernet help

[Russell Nelson]

Jim Anderson writes:
 > Looking for some help/information.
 > 
 > I am using an Adaptec Cogent Quartet Series board with Redhat Linux 5.1
 > (using the tulip driver).  I want to use one port ("eth0") to talk
 > sockets and run x-terms etc.  The other 3-ports are going to be
 > connected to dedicated devices which talk raw ethernet (i.e send/receive
 > ethernet frames).  I have attempted to use the code below, plugging in
 > the correct device name.  I get the correct ethernet hardware address,
 > but am having problems with the get.  It receives data destined for all
 > 4 devices.

Hrm.  That code looks familiar.  I didn't include support for multiple
Ethernet adapters in it.  In my application, I only cared about a
single Ethernet.  It must be possible to distinguish on receive, but
off top of my head I don't know how to do it.

-- 
-russ nelson <rn-sig@crynwr.com>  http://crynwr.com/~nelson
Crynwr supports Open Source(tm) Software| PGPok |   There is good evidence
521 Pleasant Valley Rd. | +1 315 268 1925 voice |   that freedom is the
Potsdam, NY 13676-3213  | +1 315 268 9201 FAX   |   cause of world peace.