difficulty with second nic

[Jeff Forbes]

I have a smp system with two linksys NICs. Both cards are identified by the 
driver

tulip.c:v0.91g 7/16/99 becker@cesdis.gsfc.nasa.gov
eth0: Lite-On PNIC-II rev 37 at 0xa400, 00:A0:CC:35:D9:20, IRQ 19.
eth1: Lite-On 82c168 PNIC rev 32 at 0xa800, 00:A0:CC:28:B0:B9, IRQ 19.
eth1:  MII transceiver #1 config 3100 status 7809 advertising 01e1.

but, the second card receiver and transmitter is stopped.
Can anyone suggest what might be the problem?


tulip-diag.c:v1.19 10/2/99 Donald Becker (becker@cesdis.gsfc.nasa.gov)
Index #1: Found a Lite-On PNIC-II adapter at 0xa400.
  Port selection is 100mbps-SYM/PCS 100baseTx scrambler, half-duplex.
  Transmit started, Receive started, half-duplex.
   The Rx process state is 'Waiting for packets'.
   The Tx process state is 'Idle'.
   The transmit threshold is 128.
   The NWay status register is 000000cc.
  The current PNIC-II MAC address is 00:a0:cc:35:d9:20 (a000a000 35cc20d9).
  The current PNIC-II WOL address is 00:a0:cc:35:d9:20.
   Internal autonegotiation state is 'Autonegotiation disabled'.
Index #2: Found a Lite-On 82c168 PNIC adapter at 0xa800.
  Port selection is 10mpbs-serial, half-duplex.
  Transmit stopped, Receive stopped, half-duplex.
   The Rx process state is 'Stopped'.
   The Tx process state is 'Stopped'.
   The transmit threshold is 72.
  Use '-a' or '-aa' to show device registers,
      '-e' to show EEPROM contents, -ee for parsed contents,
   or '-m' or '-mm' to show MII management registers.
Jeff Forbes, Ph.D.
Thistle Works
www.thistleworks.net