[tulip] Conexant LANfinity no longer works with tulip driver?

[Marinho Barcellos]

Donald Becker wrote:

> > [root@tyne root]# ifconfig
> > eth0      Link encap:Ethernet  HWaddr 00:50:8B:AB:1A:80
> >           UP BROADCAST RUNNING MULTICAST  MTU:1500  Metric:1
> >           RX packets:1698 errors:0 dropped:0 overruns:0 frame:0
> >           TX packets:0 errors:4 dropped:0 overruns:0 carrier:4
> >           collisions:0 txqueuelen:100
> 
> You must be running a full duplex link -- the Conexant chip reports
> every transmit packet as a carrier error in full duplex mode.

I have tried with no avail to put the card in half duplex mode,
by including the following line in /etc/modules.conf

options tulip debug=3 full_duplex=0,0

what's wrong?

Another question: anyone knows if tulip should
appear in /etc/modules, the file that names the modules to be
load during boot? and what about pci-scan?

thanks, Marinho.
=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=--=-=-=-=-=-=-=
Prof. Marinho Barcellos      marinho@exatas.unisinos.br
PIP/CA - Centro 6            http://www.inf.unisinos.br/~marinho/ 
UNISINOS - Universidade do Vale do Rio dos Sinos
Av. Unisinos, 950            Phone: (051) 590-3333 ext.1639
Sao Leopoldo, RS, Brazil     CEP 93022-000     FAX 5908162
=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=--=-=-=-=-=-=-=