[tulip] Tulip (ADMtek) under Suse 7.2

[Andre Belem]

Hi Donald,

Ops ! I'm so sorry ... I sent you the results of tulip-diag, but using the built-in
Suse driver, not the new one. The EEPROM is readable. I loaded the tulip driver and
running tulip-diag obtained that: -- see below --

hope that is enough to get an idea about the problem.

Andre
----------
tulip-diag.c:v2.08 5/15/2001 Donald Becker (becker@scyld.com)
 http://www.scyld.com/diag/index.html
Index #1: Found a Accton EN1217/EN2242 (ADMtek Comet) adapter at 0x1c00.
This chip has not been assigned a valid IRQ, and will not function.
 This must be fixed in the PCI BIOS setup.  The device driver has no way
 of changing the PCI IRQ settings.
 See  http://www.scyld.com/expert/irq-conflict.html  for more information.
Accton EN1217/EN2242 (ADMtek Comet) chip registers at 0x1c00:
 0x00: fe590000 ffffffff ffffffff 00000000 00000000 fc00c810 ff970155 fffe4010
 0x40: fffe0000 fff0dff8 00000000 fffe0000 00000000 00000200 00000000 c40ffec8
 Extended registers:
 80: 0000c810 03fe4010 a04c0004 0000ff00 00000000 00000000 00000000 ffe0f000
 a0: f0000000 16969000 ffff707a 00000000 00000000 00000000 00000000 00000000
 c0: 00000000 00000000 00000000 00000000 00000000 00000000 00000000 00000000
 e0: 00000000 00000000 00000000 00000000 00000000 00000000 00000000 00000027
 Comet duplex is reported in the MII status registers.
 Transmit stopped, Receive stopped, half-duplex.
  The Rx process state is 'Stopped'.
  The Tx process state is 'Stopped'.
  The transmit threshold is 128.
 Interrupt sources are pending!  CSR5 is fc00c810.
   Link passed indication.
   Timer expired indication.
   Early Rx indication.
  Comet MAC address registers 16969000 ffff707a
  Comet multicast filter 0000000000000000.