[tulip] ana-6944

[Ben Greear]

Marius Lindh wrote:
> 
> > > I'm having some troubles with my adaptec ana-6944a/tx card using tulip
> and 2.2.19. I get the card up running with all fourports, and are able to
> define ips to all eth
> > > (eth0-eth3). But, the trouble is, that when I use the differents ips,
> all of them are going to the eth i started first. (Both in and out). Check
> out if they used the same mac
> > > address, and it did (to different ip's). When I run ifconfig, the
> different ip gots different mac-addreses..
> > >
> > > Anyone got any good ideas? Please ;-)
> > >
> > > - Marius Lindh
> > Try using ping with the -I option too specify the right port and see
> > if that works.  If it does, then you may need to turn on arp_filter
> > and/or fix your routing...
> I have tryed this.
> 
> i.e.:
> eth0 = 192.168.0.80
> eth1 = 192.168.0.81
> 

Try ping -I eth0 192.168.0.100
and
ping -I eth1 192.168.0.100


Try turning on ARP filter:
echo 1 > /proc/sys/net/ipv4/conf/all/arp_filter


You do realize you have two interfaces on the same subnet on the same
machine, that is not a normal thing to do....

Ben

> ping -I 192.168.0.80 192.168.0.100
> and
> ping -I 192.168.0.81 192.168.0.100
> 
> are using the same ethernet interfaces.. If i'll do the pinging from
> 192.168.0.100 to 192.168.0.80 and 192.168.0.81 and run arp -a , i get the
> same mac-addresses on both 80 and 81...
> 
> - Marius Lindh
> 
> _______________________________________________
> tulip mailing list, tulip@scyld.com
> To change to digest mode or unsubscribe visit
> http://www.scyld.com/mailman/listinfo/tulip

-- 
Ben Greear <greearb@candelatech.com>          <Ben_Greear@excite.com>
President of Candela Technologies Inc      http://www.candelatech.com
ScryMUD:  http://scry.wanfear.com     http://scry.wanfear.com/~greear