[eepro100] Re: wait_for_cmd_done timeout in 2.4.19-re2-ac2

[Ben Greear]

Jeff Garzik wrote:

> Ben Greear wrote:
> 
>>My EEA2 motherboard with eepro100 driver screwed up again today.
>>This seems to be the same old issue with the eepro100 being
>>connected to a 10bt hub.  I believe this kernel has all of the
>>patches from the Sun engineer (sparker), but maybe it doesn't??
>>
>>The error is: wait_for_cmd_done timeout!
>>
> 
> What driver and kernel version?


2.4.19-pre2-ac2


> What does 'dmesg' show upon hardware init


eepro100.c:v1.09j-t 9/29/99 Donald Becker http://www.scyld.com/network/eepro100.html
eepro100.c: $Revision: 1.36 $ 2000/11/17 Modified by Andrey V. Savochkin <saw@saw.sw.com.sg> and others
PCI: Found IRQ 11 for device 01:08.0
eth0: Intel Corp. 82820 (ICH2) Chipset Ethernet Controller, 00:03:47:C8:3E:D2, IRQ 11.
   Board assembly 000000-000, Physical connectors present: RJ45
   Primary interface chip i82555 PHY #1.
   General self-test: passed.
   Serial sub-system self-test: passed.
   Internal registers self-test: passed.
   ROM checksum self-test: passed (0x04f4518b).



> 
> 


-- 
Ben Greear <greearb@candelatech.com>       <Ben_Greear AT excite.com>
President of Candela Technologies Inc      http://www.candelatech.com
ScryMUD:  http://scry.wanfear.com     http://scry.wanfear.com/~greear